OneNET IoT Platform Platform Introduction Introduction Manual Guidline for Device Development Guideline for Application Development
API
API Usage API List SDK MQTT LwM2M EDP Modbus TCP
HTTP Push

HTTP Push

The platform provides HTTP Push function, which can proactively send device-related data and messages to the application server in the form of HTTP/HTTPS POST requests.

Follow below steps to enable the HTTP PUSH service:

step 1 Enter the Developer Center, select Data Push ->HTTP PUSH, click Add Global Push, as shown in the following picture:

推送入口

Step 2 Fill in the server URL address used to receive the data and the customized token (token can be used to verify whether the request is from OneNET). Select the data stream that needs to push the new data point by specifying the datastream; click Associate as shown in the following picture:

推送配置

Step 3

In the pop-up menu bar, select the datastream that you want to push data, and after selecting, the push service will push the new data point in the selected data stream, as shown in the following picture:

关联数据流模板

Step 4

Configure push timing intervals and quantity accumulations as needed, as shown in the following picture:

  • After configuring the push interval, data will be periodically pushed at intervals
  • After configuring the number of accumulations, data will be pushed after messages will be accumulated to a certain number

时间间隔

Step 5

Follow the application developer guide to deploy the application server receiving service, click Add , and you can see that the service is in enabled state after success, as shown in the following picture:

配置成功

results matching ""

    No results matching ""